Displaying SNMP related information
233
IPLink Software Configuration Guide
20 • SNMP configuration
Mode:
Configure
Use the
no
command option to remove s SNMP trap target setting.
Example:
Specifying the default SNMP trap target
In the following example the NMS running on host with IP address 172.16.224.44 shall be defined as SNMP
trap target. Since the NMS requires that SNMP message headers have a community of Not4evEryOne the secu-
rity-name argument is set accordingly.
2803-01(cfg)#snmp target 172.16.224.44 security-name Not4evEryOne
Displaying SNMP related information
Displaying the SNMP related configuration settings is often necessary to check configuration modifications or
when determining the behavior of the SNMP agent running on an IPLink device.
This procedure describes how to display information and configuration settings for SNMP
Mode:
Configure
Example:
Displaying SNMP related information
This example shows how to display SNMP configuration information.
2803-01(cfg)#show snmp
SNMP Information:
hostname : 2803-01
location : Office, 3rd floor, Patton Electronics Co.
contact : Lorenz Born, Phone 533
Hosts:
172.16.224.44 security-name public
Targets:
172.16.224.44 security-name Not4evEryOne
Communities:
public access-right ro
Not4evEryOne access-right rw
Step
Command
Purpose
1
node(cfg)#snmp target
IP-address-of-node
security-name
community
Configures a SNMP trap target with IP-address-of-
hostanme
node
that receives trap messages of this
IPLink device, using the security name
community
on the target.
Step
Command
Purpose
1
node(cfg)#show snmp
Displays information and configuration settings for SNMP