Software IP interface configuration task list
119
IPLink Software Configuration Guide
11 • IP interface configuration
Example:
Create IP interfaces
The procedure illustrated below assumes that you would like to create an IP interface named lan Use the fol-
lowing commands in administrator configuration mode.
IPLink>enable
IPLink#configure
IPLink(cfg)#context ip router
IPLink(ctx-ip)[router]#interface lan
IPLink(if-ip)[lan]#
Deleting an IP interface
Almost every configuration command has a
no
form. In general, use the
no
form to disable a feature or func-
tion. Use the command without the
no
keyword to re-enable a disabled feature or to enable a feature that is
disabled by default.
Deleting an existing interface in the IP context is often necessary.
Mode: Context IP
Example:
Delete IP interfaces
The procedure below assumes that you would like to delete an IP interface named external. Use the following
commands in IP context configuration mode.
List the existing interfaces:
IPLink(ctx-ip)[router]#interface <?>
<interface> New interface
lan Existing interface
wan Existing interface
external Existing interface
internal Existing interface
Delete the interfaces named eth3 with the
no interface
command:
IPLink(ctx-ip)[router]#no interface external
List the interfaces again to check if the appropriate interface was deleted:
IPLink(ctx-ip)[router]#interface <?>
<interface> New interface
lan Existing interface
wan Existing interface
internal Existing interface
Step
Command
Purpose
1
node(ctx-ip)[router]#no interface
name
Deletes the existing interfaces
name