Parker FG-K17401-KW, Instruction Manual

Page: 85 / 95

MA-K17510-KW LinerSCAN manual ISSUE P.doc Page 84 of 93
8.1 Introduction
This section details the work necessary in the ‘inspection and service’ of the LinerSCAN system. It is
necessary to check the system – including, but not limited to:
•
Condition of flexible hoses
•
Condition and operation of valves
•
Condition and operation of air and power isolators
•
Checking and rectification of blockages
•
Cleaning the sensor
•
Checking calibration
•
System functionality
8.1.1 Checking the Readings – Sensor Confidence Test
A measure check can be made by inserting the calibration rod into the sensor as follows:
!
Caution:
Turn the oil valves OFF and disconnect the air supply.
Step 1: Step 2: Step3: Step 4:
Remove the oil pipes Inert check standard
rods into ‘Oil In’ and ‘Oil
Out’ Start a measure: ‘single
Measurement’ specific
to the cylinder/sensor or
‘m’ via RS232 Remove both rods
quickly when the
solenoid ‘clicks’
The result should be between the values stated on the Check Standard Rod ± 30ppm.