Parker Coral Sea, Owner'S Manual

Page: 72 / 248

[ CONTROL SYSTEM OPERATIONS MANUAL ]
May, 2015
Project: Doc: Version:
Parker Sea Recovery Coral Sea 1010016 01c
Document Name: Author: Page:
Control System Operations Manual AGE Page 36 of 129
Pressing ‘Select’ will highlight the first alarm item.
Pressing ‘Move Up’ will scroll up through the alarm list
Pressing ‘Move Down’ will scroll down through the alarm list
Pressing ‘Accept’ will clear the listed alarm notifications.
Pressing ‘Back’ will exit the alarm list. Please note the ‘Back’ button is only active if no faults or errors
are currently displayed, if errors or faults are displayed, press ‘Accept’ to exit this screen.
The operator must correct the situation before attempting to continue or restart the pump. To stop the
pump either turn the ‘High Pressure Pump’ operator back to the ‘Off’ position, or press the system
‘Auto-Stop’ button to stop all pumps simultaneously.
5.6 Auxiliary Product Pump Activation: (If installed)
Turn the ‘Aux. Pump’ operator switch on the remote pump control panel to the ‘Pump On’ position. The
pump operator indicator will not illuminate and the pump will not run until potable water has been
detected and successful activation of the product diversion valve has been completed. To stop the pump
either turn the ‘Aux. Pump’ operator back to the ‘Off’ position, or press the system ‘Auto-Stop’ button to
stop all pumps simultaneously.
5.7 Automatic/Manual Activation of System Valves
Once the operator has successfully started all connected and enabled pumps the control system will
examine the health of the system salinity sensor, if the salinity sensor reports an unhealthy state refer to
the section labeled (Manual Salinity Control Operation), if the sensor reports a healthy state the control
system will begin to monitor membrane pressures. If the system detects pressure are below the
Coral Sea Owner's Manual