Parker Coral Sea, Owner'S Manual

Page: 82 / 248

[ CONTROL SYSTEM OPERATIONS MANUAL ]
May, 2015
Project: Doc: Version:
Parker Sea Recovery Coral Sea 1010016 01c
Document Name: Author: Page:
Control System Operations Manual AGE Page 46 of 129
7. Automatic Start up Operation
Automatic start up operation is a new feature added to the Coral Sea Series of products. It allows for
virtually hands free start up of the system and all associated equipment. This automatic start up
operation can also be carried out remotely via the Modbus communications link (if installed).
Before attempting automatic start up, it is important to check that all valves are in the correct position
as previously identified in the section titled, “System settings prior to attempting operation”.
Ensure that the main circuit breaker located in the top right corner of the control panel is in the ‘ON’
position and that the ‘Power On’ Indicator on the front of the control panel is illuminated.
Ensure that the E-Stop button is not pressed in. If the E-stop button is illuminated, the button is pressed
in, release it by turning the mushroom in a clockwise direction.
Ensure no alarms or faults are currently being indicated. If the alarm light is illuminated or flashing an
alarm or performance warning is present, accept or clear these alarms before attempting to proceed.
To initiate an automatic start up of the system simply press the ‘Auto-Start’ button on the control panel
door or navigate to the ‘System Operation’ screen (See Menu Navigation). Once the screen has been
accessed press the ‘Start’ button.
Immediately after the ‘Auto-Start’ button is pressed, the green indicator light embedded in the button
will begin to flash rapidly, at this moment the system is performing system pre-checks, if a problem is
detected the system will abort the automatic start-up routine and display a system fault notification
screen detailing the problem (See System Critical Error Messages), as shown on the next page:
Coral Sea Owner's Manual