Parker Coral Sea, Owner'S Manual

Page: 62 / 248

[ CONTROL SYSTEM OPERATIONS MANUAL ]
May, 2015
Project: Doc: Version:
Parker Sea Recovery Coral Sea 1010016 01c
Document Name: Author: Page:
Control System Operations Manual AGE Page 26 of 129
4.13 Domestic Max. Salinity Level (uS/cm):
This value stated in uS/cm determines at what product water conductivity level the system will activate
the diversion valve and UV sterilizer (if fitted). Once the product water measured conductivity drops
below the number inputted here, the water maker deems the water as acceptable.
Typical values entered here are 1200 uS/cm in all applications
4.14 Domestic Min. Salinity Level (uS/cm):
This setting allows you to determine what minimum salinity level from the salinity probe will be
accepted. Domestic systems cannot produce product water with salinity lower than the value entered
here, therefore any readings below this value causes the water maker control system to reject the
salinity probe input under the suspicion that the salinity probe has been removed from the system pipe
work and is currently sitting in air.
Typical values entered here are 100 in domestic water applications
4.15 PPM Conversion Factor:
Europe and the US use different scaling factors when converting uS/cm in to PPM. Within the US a
scaling factor of approximately 0.5 is used, within Europe a factor of 0.67 is used. Press on the
conversion factor you desire, once set the selected conversion factor button will remain depressed.
Changing this scaling factor results in a different bar and numbering system on the product water
salinity monitoring page when ‘PPM’ is selected as the preferred viewing unit.
4.16 System Time and Date:
This will allow you to change the time and date stored within the touch screen. To access this high level
editing screen a password is required. Contact Parker Sea Recovery for further details
To exit the system settings screens you must press the “Save Settings’ button located in the lower right
hand corner of the second settings screen, even if you have not applied any changes to the system
settings, this button must be pressed to exit the settings screen. Failure to do so will result in an
automatic save after 60 seconds of inactivity.
Coral Sea Owner's Manual