Parker Coral Sea, Owner'S Manual

Page: 195 / 248

Coral Sea Vertical 6800
Page 7-1
Maintenance
System and void all Warranty. USE ONLY SRC
SUPPLIED PARTS.
WARNING: ELECTRICAL SHOCK HAZARD.
A Volt / Ohm Meter will be necessary. The
following installation procedures expose
the installer to High Voltage and electrical
shock hazard. Only attempt this if you are a
qualifi ed electrician and only if surrounding
conditions are safe.
REVERSE OSMOSIS MEMBRANE ELEMENT SUSCEPTIBILITY
TO CHEMICAL ATTACK:
CAUTION: Do not expose the Parker
Hannifi n System to these chemicals:
Hydrogen peroxide chloramines-T
Chlorine dioxide chlorine
Bromine phenolic disinfectants
chloramines N-chlorioisocyanurates
hypochlorite
iodine
Bromide petroleum products
or any other specifi c chemical not approved in writing by
Parker Hannifi n Corp. Use of non authorized or misuse
of authorized chemicals voids warranty. Never use
third party so called “Reverse Osmosis Chemicals” for
storage or cleaning. Third Party chemicals will dissolve
copolymer components within the Parker Hannifi n
System and will destroy the R.O. membrane element.
Use of and subsequent damage caused by non Parker
Hannifi n Chemicals are the liability and responsibility of
the operator and are not covered by the Parker Hannifi n
Warranty.
Do not connect any water line to the Parker Hannifi n
R.O. System that may contain any of the above listed
chemicals. Examples: Do not connect the Parker Hannifi n
R.O. System to the ships potable product water tank if
that tank has been treated with a Brominator as Bromine
destroys the copolymer components within the system.
Do not connect the Parker Hannifi n R.O. System to any line
that may contain chlorine or other oxidants as they destroy
the R.O. membrane element.
If you use detergents to clean the internal wetted parts of
the system ensure that they are rinsed thoroughly, wiped
and dried prior to reassembly. After the components have
been reassembled, product water can be used to remove
any feed water residue from the exterior surfaces of the
components.
7 MAINTENANCE & REPAIR
From time to time, Parker Hannifi n may make
programming changes to the Control Logic.
Other production changes are tracked by Parker Hannifi n
through the System Serial Number.
Troubleshooting methods and results can vary depending
on the operating conditions indicated on the SYSTEM
control panels.
When ever requesting assistance from Parker Hannifi n or
one of Parker Hannifi n’s service dealers,
ALWAYS PROVIDE ALL INFORMATION AND
OPERATION CONDITIONS DISPLAYED AT THE
SYSTEM CONTROL PANELS.
SERIAL NUMBER: Helps us to determine the latest
physical version and confi guration of your system which is
necessary to ensure that we provide you with the correct
information or parts.
TYPE: Tells us the production capacity of your system
which gives us a bench mark in diagnosing product water
fl ow and pressure concerns.
TIME RUNNING: Assists us in diagnosing abnormalities
that can occur at given operational time intervals such as
required pump maintenance, or R.O. membrane element
condition.
VERSION: Allows us to determine the specifi c sequential
operation of the system based on the version of the
programmed control logic.
AND Always provide us with the System Operating Voltage,
Cycles, and Phase.
QUALIFICATIONS
Technicians must have technical knowledge and ability in
the following fi elds:
a) Electrical, Electronic, Electric Motors & Circuits
b) Electromechanical & Mechanical Systems
c) Hydraulic and Liquid Pressure & Flow Systems
d) Piping and Plumbing Systems
e) Water Suction & Pressure Lines
f) Thru-Hull Fitting below & above water level
DO NOT PERFORM MAINTENANCE UNLESS:
1. The System Feed Water Sea Cock Valve is closed.
2. The system main electrical disconnect switch is
switched “OFF”, LOCKED, and TAGGED.
3. Section 10 , Drawings Section is available.
4. Use of non SRC parts will cause damage to the
Coral Sea Owner's Manual