Parker Coral Sea, Owner'S Manual

Page: 30 / 248

Coral Sea Vertical 6800
Page 4-2
Installa
tion
instructions.
CAUTION: The Membrane and Vessel
assembly is packaged with storage solution.
Avoid skin and eye contact with this solution.
In case of skin contact, rinse the skin
thoroughly with water. In case of eye contact,
fl ush repeatedly with water and notify a
physician immediately. (THE STORAGE
CHEMICAL IS WATER, SODIUM BISULFITE
& PROPYLENE GLYCOL).
per system specifi cation and wiring diagram in Section 3 .
Install all other component wiring per system specifi cation
and wiring diagram.
E. INSTALLING MAIN POWER CABLE
install main power wiring per system specifi cation and
wiring diagram in
Section 10.
IF SYSTEM COMMISSIONING AND OPERATION
WILL BEGIN WITHIN 1 OR 2 DAYS THEN
CONTINUE TO NEXT SECTION.
4.4 COMPONENT PREPARATION:
A. MEDIA FILTER
a. Remove the top entrance cover. The Filter Media used
in the Media Filter consists of two grades of sand,
which must be placed into the Media Filter from the
bottom up as follows:
1) First add approximately 50 lbs (22 kg) of Fine Angular
Gravel or Garnet 1/8 - 1/16 inches (3-1.5 mm). Fill to
1 - 3 inches (25 - 75 mm) above the bottom laterals.
2) Second add approximately 150 lbs (68 kg) of No. 20
grade Silica Sand.
b. Upon completion of the sand loading, wash off the top
of the fi lter to remove all sand from the o-ring groove.
Lubricate and replace the o-ring into its groove and
mount the top entrance cover onto the top of the fi lter
assembly.
c. Close the Media Filter Valve on the System. This
forces the fl ow of feedwater from the Booster Pump
through the Media Filter before it returns to the Pre-
Filter Inlet.
Media Filter Connections:
NOTE: Media Filter Flange Connections
are designed to mate directly to their
corresponding fl anges on the side of the
System frame. If space limitations prevent
this, connect the System Flanges to their
corresponding Media Filter Flanges with
fl exible hose or pipe.
B. RO MEMBRANE
If the System was shipped without R.O. Membrane
Elements installed, refer to
Section 6 for installation
details.
Do not install the Membrane Elements until the system is
ready for commissioning. This ensures that the Membrane
Elements do not dry out and become fouled.
If the system was shipped with Membrane Elements
installed, refer to
Section 6 for Storage and Cleaning
Coral Sea Owner's Manual