Parker Coral Sea, Owner'S Manual

Page: 156 / 248

[ CONTROL SYSTEM OPERATIONS MANUAL ]
May, 2015
Project: Doc: Version:
Parker Sea Recovery Coral Sea 1010016 01c
Document Name: Author: Page:
Control System Operations Manual AGE Page 120 of 129
19.10 Activating the backwash cycle manually while operating the system in automatic mode
If your system is operating in automatic mode the control system will automatically initiate multi-media
backwashing cycles when needed, however you can still initiate these backwash cycles manually if you
choose to do so. Please note that if you manually initiate a backwash cycle during automatic operation
the system will see this as a manual intervention; hence once the backwash cycle has been completed
the system will remain shutdown and will not automatically re-start and re-enter production mode by
itself.
To manually initiate a backwashing cycle during automatic mode press panel button #11 ‘Back Wash
Status’ (illustrated on page 7), once you press this button the controller touch screen will display the
following screen:
If you wish to cancel your request to initiate the backwashing cycle at this time press the ‘No’ button,
doing so will cancel the above screen and automatically schedule a backwashing cycle for the next time
the system is shutdown normally, if you do not wish to initiate a backwash or schedule a backwash for
later simply ignore this screen, after 60 seconds it will self cancel. If you wish to initiate the backwashing
procedure press the ‘Yes’ button on the touch screen or press panel button #11 ‘Back Wash Status’
again.
Once you press either panel button #11 or the ‘Yes’ button on the touch screen the system will begin an
automatic shutdown of the water maker and enter the automatic backwashing sequence.
Press Here To
Cancel Request
Press Here To
Start Backwash
Coral Sea Owner's Manual