Panasonic KXF-193C, Operating Manual

Page: 96 / 206

Page 4-16
Board Positioning Data
3. Board vacuum motion timing (option)
To prevent the board from being moved during board positioning and printing, the vacuum block
(option) fixes the board. And setting the vacuum start time and end time decides the timing with the
clamp motion.
Vacuum start time : When the board support begins to rise up, the timer = 0.
For the vacuum start time, input about +0.3 s as the delay time of board clamp motion.
When Inputting the vacuum end time, consider the lowering speed and lowering stroke.
Vacuum end time : When the board support begins to lower in order to eject the printed board, the
timer = 0.
Depending on the board, the solder might spread due to such things as the through hole when
the board is vacuumed. In such a case, Set “OFF” the vacuum during printing.
Vacuum during printing : Set whether to use the board vacuum function during printing.
For the vacuum start time, input about +0.3 s as the delay time of board clamp motion.
When Inputting the vacuum end time, consider the lowering speed and lowering stroke.
4. Board flattening (option)
Use this when using a thin or warped board or when the board is not positioned properly. Normally,
set it “OFF”.
4-6-2 Editing Board Positioning Data
1
. Click on BoardPositionData .
• [BoardPositionData] window opens.
2
. Set the board vacuum motion timing.
∗
The board suction motion is an option.
3
. Set whether to flatten the board when
the it is positioned.
∗
The board flattening motion is an option.
193C-E-EMA04-A02-00