Panasonic KXF-193C, Operating Manual

Page: 91 / 206

Page 4-11
DA
T
A
MODIFICA
TION
4
4-4 Creating Board Data
4-4-1 Board Data
1. Board size
Enter the size of the board. “L (length)” is the length of the surface parallel to the board transport
direction. “W (width)” is the length of the surface vertical to the board transport direction. T (thick-
ness)” is the thickness of the board.
2. Coordinates reference
Choose a board corner as the coordinates reference.
Right-Rear reference is set as the standard setting. In this case, the right rear corner is the origin
(0, 0) that is the reference for printing coordinates, etc.
3. Origin offset
Enter the offset value. Origin offset is used to set the origin (0, 0) onto a position that is offset from
the board corner as the coordinates reference. Offset value is the measurement from the board
corner selected as the coordinates reference to the origin.
4. Stop position (This can be set only on SP22.)
This displays the position on X-Y table where the board will be clamped. It is automatically calcu-
lated on the basis of the board size X, the mask plate-making reference and the mask plate-making
reference origin (X).
193C-E-EMA04-A02-00
L (length)
W (width)
T (thickness)
Range to be input
50mm to 460mm
50mm to 360mm
0.5mm to 4.0mm
X (mm)
Y (mm)
Range to be input
0 to board size X
0 to board size Y
193C-EPt-EdBd-001