T
T
91
90
15
15
∙ Measure the water
temperature with a digital
thermometer and compare
the measured temperature
with the one displayed on
the keypad.
If the measured temperature
corresponds to the one on
the keypad (higher than
108°F / 42°C) and the
exterior temperature is high:
If the measured temperature
corresponds to the one on
the keyboard (higher than
108°F / 42°C) and the
exterior temperature is not
high:
The spas water temperature has reached 108°F (42°C).
OH Error Message
If the measured temperature
is different from the one
displayed on the keypad
(lower than 108°F / 42°C):
∙ Turn the spa off and turn
it back on to reinitialise the
system.
∙ For in.yj-re control system,
if the error persists,
replace the probe.
∙ For in.yj, in.ye, in.yt and
in.xe control systems, if
the error persists, replace
the water heater.
∙ If error still persists,
replace the control system.
∙ Set the set point value to a
temperature below that of
the spa water.
The keypad’s water heater
indicator should turn off.
∙ Turn off all pumps*.
If one of the pumps is
still running, replace the
control system.
∙ The pump may be
excessively heating the
water during the filtration
cycle. Reduce filtration
cycle length.
* Note: The main pump
may not turn off if you are
currently running a filtration
cycle.
∙ Remove the spa cover and
let the spa cool down.
∙ Add cold water and
reduce filtration cycle
length.
∙ If error still persists,
replace the control system.
If Pump 1, 2, 3, 4, 5 or The Blower Is Not Working:
98
∙ Verify if an error message
is displayed on the
keypad. If so, refer to the
corresponding section.
∙ Ensure the selected
low-level configuration is
compatible with your spa’s
components.
∙ Verify the indicator linked
to your pump and blower
on the keypad turns on
when you press on the
corresponding key.
If the indicator lights up:
∙ Verify your pump is working on both speeds (if dual speed
pump) and your accessories work correctly (i.e. blower).
PUMP 1, 2, 3, 4, 5 OR THE BLOWER IS NOT WORKING
in.yj
in.ye and in.yt
in.xe
If the indicator does not light up:
∙ Use a replacement keypad to verify the state of the original.
∙ Replace the keypad if defective.
∙ If the keypad works correctly, replace the control system.
