1
+
1
+
21
20
4
4
on/off
Turn in.clear ON
(icon red)
Slide the right wheel until the power on/off icon is
highlighted in the middle. Press the icon to turn
in.clear on.
Turn in.clear OFF
(icon yellow)
Press icon for 5 seconds to confirm power off.
Turn in.clear OFF
(icon green)
Press the icon to turn the in.clear off.
bromicharge™ level
To perform a water test, slide the right wheel until
the add BromiCharge™ icon is highlighted in the
middle.
There is no need to add sodium bromide if the
indicator is in the green zone.
When adding sodium bromide, the gauge
indicator will gradually shift to the right. When
adding clean water to the spa, the indicator will
shift to the left.
In order to achieve the proper level, start pumps
and add 227g (0.5 lb) of BromiCharge™ at a time
and always allow five minutes for the gauge to
react before adding more sodium bromide.
Note: When performing a test, the BromiCharge™
gauge indicates the approximate sodium bromide
level of the spa water.
The green zone in the centre area of the gauge
should be targeted for optimal performance.
direct to function
selection wheel:
on/off -
bromicharge -
boost level -
maintenance -
status and messages
mode selection
wheel:
in.clear icon
sanitization mode
(only available if the system detects a connected in.clear water sanitization system)
To select the sanitization mode, slide the left wheel up or down until the in.clear icon menu is highlighted in the middle.
In the sanitization page you can access the following:
∙ in.clear on/off
∙ Boost level
∙ Bromicharge
∙ Maintenance level
To select an item, slide the right wheel until the desired icon is highlighted in the middle.
boost level
maintenance level
Note: Use a test kit to check the bromine level. It
should be between 3-5 ppm. If the bromine level
stays within that range for three consecutive days,
your maintenance level is well adjusted.
Modify the Boost Level
Boost mode is activated automatically five
minutes after starting a pump. Boost mode
increases the bromine generation rate to keep the
water clear, clean and soft. As a rule of thumb, its
level corresponds to the number of bathers.
To modify the boost level, slide the right wheel
until the boost icon is highlighted in the middle
and use the up or down arrow keys to adjust the
level.
Click on the the level icon to confirm your
selection.
Modify the Maintenance Level
To verify or modify the maintenance level, slide
the right wheel until the maintenance icon is
highlighted in the middle.
The recommended maintenance level is 12.
Use the Up or Down arrow keys to adjust the
level.
The level can be adjusted by increments of "2"
using the Up and Down arrow keys.
Note that it is not recommended to change the
maintenance level at steps greater than "2".
A confirmation will be asked by the system if you
do.
If you do change the maintenance level steps,
retest the bromine level the day after. If the
bromine is higher than 5 ppm, decrease the
maintenance level. If the bromine is lower than
3 ppm, increase it. Repeat until the test reads a
bromine level in the 3-5 range.
