OSYPKA PACE 203H, Instructions For Use Manual

Page: 92 / 139

PACE 203H – Instructions for Use
92 / 139 5I-17-016X-B-20
lower display, accompanied by an
acoustic warning signal. The warning
message alerts the user about the prob-
lem, and how to solve it. Warning mes-
sages appear after the recognition of
conflicts. Depending on the warning
message, it disappears automatically after a few seconds, or after confirmation
by the user. The user confirms the warn-
ing message by pressing the key
Un-
lock / Lock
. Confirmation causes the
warning message to disappear. Table 66
shows a list of these warning messages.
PACE 203H
Warning Message
Meaning / Cause Measures to Eliminate the
Conflict / Error See
Chapter
Increase
MTR to
increase
Rate
The user has attempted to increa-
se the rate. This led to a conflict
(type a), because MTR is set at an
excessively low value. Increase MTR or set to "Auto
MTR" before further increase of
rate. 9.22.7
Decrease
PVARP or
A-V Delay
to increase
Rate
The user has attempted to increa-
se the rate. This led to a conflict
(type b or d), because the sum of
PVARP and A-V Delay is exces-
sively high. Decrease PVARP and/or A-V
Delay or set to "Auto PVARP"
and "Auto AVD" before further
increase of rate.
Alternatively, in case of an
implicit conflict (type d) be-
tween PVARP plus A-V Delay
and automatically set MTR,
manually set MTR to a lower
value. 9.22.7
Decrease
A-V Delay
to increase
Rate
The user has attempted to increa-
se the rate. This led to conflict
(type b or c) because the A-V
Delay is excessively high. Decrease A-V Delay or set to
"Auto AVD" before further
increase of rate. 9.22.7
Decrease
PVARP or
Rate
to increase
A-V Delay
The user has attempted to increa-
se A-V Delay. This led to conflict
(type b), because there is inade-
quate time for a long A-V Delay in
the presence of a high rate and a
long PVARP. Decrease PVARP and/or rate
before further increase of A-V
Delay. 9.22.7
Decrease
Rate
to increase
A-V Delay
The user has attempted to increa-
se A-V Delay. This led to conflict
(type c), because there is inade-
quate time for a long A-V Delay in
the presence of high rate. Decrease Basic Rate before
further increase of A-V Delay. 9.22.7