Oracle Acme Packet 4500, Hardware Installation And Maintenance Manual

Page: 51 / 114

SYSTEM INSTALLATION
Acme Packet 4500 Hardware Installation and Maintenance Guide 45
5. Secure the 10-32 screw to the nut bar you are holding in place. Refer to the
following exploded view of the procedure.
Figure 4 - 53. Securing the Screws and Nut Bar to the Stationary Rail and Rack
Do not completely torque the screws; leave a small amount of play at this point.
6. Repeat Steps 3 - 5 for the other mounting point.
Figure 4 - 54. Stationary Slide Securely Attached to the Equipment Rack
7. Repeat this procedure for the other stationary slide
To install the stationary rails on the rear of a square-hole equipment rack:
Note: The images used in this procedure refer to the stationary slide
without slide extenders installed. The procedure is essentially the same
with the slide extender flange placed on the outside of the rear rack rail.
1. Locate the following components:
•
4 x 10-32 x 5/8” screws
• 2 x nut bar