Oracle Acme Packet 4500, Hardware Installation And Maintenance Manual

Page: 68 / 114

62 Acme Packet 4500 Hardware Installation and Maintenance Guide
SYSTEM INSTALLATION
The following figure shows a Acme Packet 4500 with media network cable
properly connected and inserted in
S0P0 .
Figure 4 - 86. Connected S0P0 Port
3. Repeat Steps 1 through 2 for each additional Ethernet cable you connect to your
Acme Packet 4500.
GbE SFP Optical
Cabling Procedure This section explains how to cable an Acme Packet 4500 configured with GbE optical
NIUs. Standard single mode or multimode fiber optic cabling with duplex LC
connectors are used to connect the SFP-based NIUs to your network.
Fiber Optic Cable
Handling When handling a fiber optic cable:
•
Never touch the polished end of fiber cable.
• To prevent serious eye damage, never look directly into a fiber optic cable
connector or mating adapter.
•
Clean all fiber optics before installing them into your network according to
prescribed procedures.
• Ensure that the bend radius of your fiber cables is kept to a minimum of 3” or
that specified by the fiber cable manufacturer.
• Perform all cabling procedures according to the established standards for your
organization.
To connect network GbE optical cabling to the GbE optical physical interface cards:
1. Locate the GbE fiber optic cables you plan to connect to the Acme Packet 4500.
2. Insert the duplex LC connector on the end of the fiber cable into one of the NIU
SFP optical transceivers. The connector should click and lock in place when you
insert it properly. These media and signaling ports from left to right are labeled:
S0P0 , S0P1 , S1P0 , S1P1 .
Figure 4 - 87. Optical Transceivers