Oracle Acme Packet 4500, Hardware Installation And Maintenance Manual

Page: 34 / 114

28 Acme Packet 4500 Hardware Installation and Maintenance Guide
GRAPHIC DISPLAY
The following information is displayed for each configured interface you scroll to:
• Interface slot and port: interface status
•
Input packets, output packets
• Input error packets, output error packets
Slot 1: Port0 UP
PKT IN: 1,001K OUT: 223K
ERR IN: 0 OUT: 0
To use the INTERFACE menu in the graphic display:
1. From the top menu of the graphic display, press the Enter button.
2. Press the Up or Down button to scroll to the INTERFACE selection.
3. Press the Enter button.
4. Press the Up or Down button to scroll through the list of configured physical
interfaces.
5. Press the Enter button to refresh the display.
6. Press the Up or Down button to scroll to the RETURN selection.
7. Press the Enter button to return to the Top Menu.
BOOT PARAMS
The BOOT PARAMS display allows you to view the same information configured in
the
bootparam ACLI configuration. The BOOT PARAMS selection displays the IP
information necessary to connect to the first Ethernet interface, eth0 , located on the
rear of the Acme Packet 4500. This interface is used primarily for maintenance,
configuration, and downloading software images.
The following information for eth0 is displayed under the BOOT PARAMS menu:
• IP address
•
Netmask in hexadecimal format
• Gateway IP address
inet: 192.168.0.2
mask: ffff0000
gw: 192.168.0.1
To use the BOOT PARAMS menu in the graphic display:
1. From the top menu of the graphic display, press the Enter button.
2. Press the Up or Down button to scroll to the BOOT PARAMS selection.
3. Press the Enter button. The BOOT PARAMS information is displayed.
4. Press the Up or Down button to scroll to the RETURN selection.
5. Press the Enter button to return to the Top Menu.