Oracle Acme Packet 4500, Hardware Installation And Maintenance Manual

Page: 53 / 114

SYSTEM INSTALLATION
Acme Packet 4500 Hardware Installation and Maintenance Guide 47
4. Align the chassis slide with the Acme Packet 4500 side panel. Position the large
marker hole at the front of the slide with the Acme Packet 4500 chassis. The
remaining three tapped holes will align with the holes in the slide. The following
image points out the tapped holes used for mounting the chassis slide.
Figure 4 - 58. Mount Points for Installing the Chassis Slide
5. Use 3 x 6-32 x 5/16” screws to secure the chassis slide to the chassis. Notice that
the large hole in the slide (at right) is positioned toward the front of the Acme
Packet 4500 chassis.
Figure 4 - 59. Chassis Slide Installed on Chassis
6. Repeat this procedure for the other side of the Acme Packet 4500 chassis.
Installing the
Chassis in the
Rack
You now lift the Acme Packet 4500 and install it into the rack. To prevent personal
injury or damage to the Acme Packet 4500, follow these guidelines:
• This installation requires two people and should not be attempted otherwise.
•
Follow your organization’s best practices for lifting and installing heavy
components into an equipment rack.
•
Ensure that the Acme Packet 4500 chassis remains supported until you have
completely installed it into the equipment rack.
To install the Acme Packet 4500 chassis in the equipment rack:
1. Lift the Acme Packet 4500 into the correct position in the equipment rack.
2. Insert the chassis slides into the stationary slides.
Figure 4 - 60. Chassis Slide Mount Points