Omron SYSMAC C200H-CT001-V1, Operation Manual

Page: 23 / 110

9
This switch must be set before the Counter Unit is mounted. It is not neces-
sary to set all the pins for all operating modes. Refer to 3-2 Input Selection
and Section 4 Data Allocation and Operating Modes for operational details.
1 2 3 Input type
OFF OFF OFF
OFF OFF
OFF
OFF
ON
ON
ON
ON ON
*
*
*
Normal
x2
x4
Up and down pulses
Pulse and direction
Offset phases
1 2 3 4 5 6 7 8
ON
Input Selection
Pins 1 through 3 are used to select the type
of inputs for inputs A and B.
4 5 Function
OFF ON
ON ON
Input Z effective on falling edge.
Input Z effective on rising edge.
OFF Input Z inoperative *
For Operating Mode 1 or 2: Input Z
6 7 Function
OFF ON
ON ON
Control input IN1 effective on
falling edge.
Control input IN1 effective on
rising edge.
OFF Control input IN1 inoperative *
This setting is effective only for operating
modes 1,2, and 3.
In modes 4, 5, and 6, control inputs IN1 and IN2
are always effective on their rising edges
8 Function
ON Reset bit effective on rising edge.
OFF Reset bit inoperative
This setting is effective only for operating
modes 1,2, and 3.
Control Input IN1
Internal Reset Bit
4 5 Function
* ON
Start on control input IN2.
OFF
Start on START command
(IR n, bit 00).
*
For Operating Mode 3: Start Input
*Pins marked with asterisks are not used.
Back Panel DIP Switch
Switch Settings
Section 2-1