Omron SYSMAC C200H-CT001-V1, Operation Manual

Page: 110 / 110

97
Revision History
A manual revision code appears as a suffix to the catalog number on the front cover of the manual.
Cat. No. W141-E1-4
Revision code
The following table outlines the changes made to the manual during each revision. Page numbers refer to the
previous version.
Revision code Date Revised content
1 September 1989 Original production
2 December 1990
Converted to current format.
2A October 1994 Complete layout change. Scan time changed to cycle time throughout the manual. Correc-
tions made and product functionality added as follows:
Page 9: Setting of pin 4 added for preset counter operating mode.
Pages 10, 11: Row B information corrected for pin number 8.
Page 16, 17: Power supply voltage changed to 12 VDC.
Page 35: Note added on operation of transfer complete flag.
Page 45: Paragraph added to START explanation. Explanation of ENABLE OUTPUT
corrected.
Page 46: “I/O” area changed to “IR” area.
Page 48: Second instruction line and function code of DIFD corrected.
Page 50: Second instruction line and function code of DIFD corrected.
Page 58: Explanation changed to say that either START or external control input IN2 can
be used as start signal for counter.
Page 62: Output numbers corrected for bits 10 through 15.
Page 64: Explanation of ENABLE OUTPUT corrected.
Page 66: Information added on operation of counting flag.
Page 67: Information corrected concerning CT001-V1 support of bit 07.
Page 73: Notes added after table.
Page 85: Switch setting corrected.
Page 99: Specifications for the external signal level and output level changed. Note add-
ed concerning response speed.
Page 100: Leak current corrected to 0.1 mA.
Pages 101, 102: Note added on signal length of IN1 and IN2.
2B July 1995 The following corrections/additions were made.
Page 12: Diagram of connector pin numbers added.
Page 40: The following mistake was deleted: When counting is started, the current
counter value is reset to 0 and external outputs #0 through #7 are turned OFF.
Pages 41, 58: Note added on useable DM and IR words.
Page 45: Precaution added on Z flag operation.
2C August 1996 Page 14: The pin number B15 for the fourth circuit corrected to B12.
Page 37: “Lower limit” corrected to “upper limit for words m+12 and m+13.
Page 38: Output numbers for bits 01 to 15 of input word n+9 corrected to 1 to 15 respec-
tively.
3 April 2000 A precautions section was added to the beginning of the manual and the following changes
were made.
Pages 36 and 69: Notes added.
4 September 2000 Page xiii: Minor change made to wording of information on mounting.
Pages 14 and 16: Changes made to graphics in several places.