7
．
EtherCAT Connection Procedure
31
7.4.2. Checking the Sent and Received Data
Confirm that the correct data are sent and received.
Sufficiently confirm safety before you change the values of variables on a Watch
Tab Page when the Sysmac Studio is online with the CPU Unit. The connected
devices may operate regardless of the operating mode of the Controller.
In the procedure of this section, the SCON-CA Controller will run. Confirm safety
before operation. If you cannot confirm safety, do not proceed to this section
after completing until
Section 7.4.1
.
If you proceed to this section, make sure to complete all the steps and place the
Destination Device in the safe state.
1
Select
Watch Tab Page
from the
View Menu.
2
Select the
Watch1
Tab.
3
As shown below, enter the following
name of the variables for
monitoring. Click the
Input Name…
in the
Name
Column to enter a new
name.
E001_Out_Bit04_SON
E001_In_Status_Signal_2004_05
4
Select
Binary
from the pull-down
list of Display format of
E001_In_Status_Signal_2004_05
.
The Display format is selected to
Binary, and the Online value is
displayed in binary.
Summary of Contents for SCON-CA
Page 40: ...2015 0115 1213 P585 E1 02 ...
