7
．
EtherCAT Connection Procedure
14
7.2.2. Parameter Settings
Set the parameters for the SCON-CA Controller.
Parameters are set by PC Interface Software for RC. Install the software and USB Driver to
the Personal computer beforehand.
Additional Information
For information on how to install drivers, etc., refer to the
PC Software RCM-101-MW,
RCM-101-USB Operation Manual
(Cat. No. ME0155).
1
Connect the SCON-CA
Controller to the Personal
computer with a USB cable,
USB conversion unit, and
Communication cable.
*Connect the USB cable to the
USB port on the Personal
computer. Connect the
Communication cable to the
SIO Connector on the
SCON-CA Controller.
2
Set the Operation Mode Setting
Switch on the front of the
SCON-CA Controller to the
MANU side.
3
Turn ON the power supply to the
SCON-CA Controller.
4
Start the PC Interface Software
for RC from the Personal
computer.
Personal
computer
USB cable
Communication
cable
USB conversion
unit
SIO connector
Summary of Contents for SCON-CA
Page 40: ...2015 0115 1213 P585 E1 02 ...
