Omron SCON-CA, Connection Manual

Page: 10 / 40

5
．
Applicable Devices and Device Configuration
7
Precautions for Correct Use
The connection line of EtherCAT communications cannot be shared with other Ethernet
networks.
Do not use devices for Ethernet such as a switching hub.
Use the Ethernet cable (double shielding with aluminum tape and braiding) of Category 5 or
higher, and use the shielded connector of Category 5 or higher.
Connect the cable shield to the connector hood at both ends of the cable.
Precautions for Correct Use
Update the Sysmac Studio to the version specified in this section or higher version using the
auto update function.
If a version not specified in this section is used, the procedures described in
Section 7.
and
subsequent sections may not be applicable. In that case, referring to the
Sysmac Studio
Version 1 Operation Manual
(Cat. No. W504), use the equivalent procedures described in
this document.
Additional Information
For specifications of the Ethernet cables and network wirings, refer to
Section 4. EtherCAT
Network Wiring
of the
NJ-series CPU Unit Built-in EtherCAT(R) Port User's Manual
(Cat. No.
W505).
Additional Information
The system configuration in this document uses USB for the connection to the Controller.
For how to install a USB driver, refer to
A-1. Driver Installation for Direct USB Cable
Connection
of the
Sysmac Studio Version 1 Operation Manual
(Cat. No. W504).
Additional Information
The system configuration in this document uses USB for the connection to the SCON-CA
Controller. For how to install a USB driver, refer to
Section 1.3.3. How to Install the USB
Conversion Adapter Driver Software
of the
PC Software RCM-101-MW, RCM-101-USB
Operation Manual
(ME0155).