Omron K3TS, Operation Manual

Page: 76 / 97

%
8-2 Measurement of Discs
The following operations are possible with K3TS:
•
The output signal of the linear sensor varies continuously. The
peak-to-peak hold function makes it possible to measure the difference be-
tween the maximum value and minimum value of the signal in order to
measure the decentering of disc-shaped objects.
•
The measuring operation is carried on while the TIMING input (a push
switch in this example) is ON. When the TIMING input is OFF, the K3TS will
hold the final result.
Settings
Level 3
(A only)
(No previous average comparison)
(Peak-to-peak hold)
Level 2
(4 to 20 mA)
---
---
Level 1
to (When the comparative output is used, set HH, H, L, and LL.)
= ---
If X
2
= 20.00, Y
2
= 20.00
If X
1
= 4.00, Y
1
= 4.00
(set to if necessary, after all setting operations have been com-
pleted.)
“---” indicates parameters that are not displayed.
The decentering of the shafts of objects can be measured. If they are not
metal objects, use an optical displacement sensor or a supersonic displace-
ment sensor.
" #%
Section 8-2