&/
With the teaching function, it is possible to retrieve the actual measured val-
ues and set them as a linear output range. The Thumbwheel Switches Mod-
els do not incorporate a teaching function.
In order to perform this operation, follow the instructions outlined in the flow
diagram which show how to change set value L
H
from
to
.
Press the Display Key to write the L
H
value.
RUN mode
Press and hold the Level Key for 2 seconds to select level 1.
Setting level 1
Press the Display Key.
LED Models
Press and hold the Level Key for
1 second to return to RUN mode.
Press the Shift Key several times until
is displayed.
Press the DATA TEACH Key. The present measured value will be displayed. (The H
LED indicator blinks. Zero suppress is displayed.
Press the DATA TEACH Key again. Measurement is halted and the value displayed
immediately before the key was pressed is displayed.
Repeat the 1 through 3 operations to write the L
1
value.
Press the Display Key. This completes the setting.
(1)
(2)
(3)
Linear Output Range
#
Section 6-3
Summary of Contents for K3TS
