Omron K3TS, Operation Manual

Page: 35 / 97

/
Minimum Hold When the K3TS is set to on operating parameter 3, the K3TS continues
data sampling while the TIMING input is ON. When the TIMING input is OFF,
the K3TS displays the minimum value of the data that has been sampled and
holds the value until the next TIMING input signal is OFF.
ON
Input waveform
0 (V)
OFF
Power ON
In this period,the displayed
process value is “
”.
First TIMING in-
put after power
is ON.
Minimum hold value
Peak-to-Peak Hold When the K3TS is set to on operating parameter 3, the K3TS continues
data sampling while the TIMING input is ON. When the TIMING input is OFF,
the K3TS displays the peak-to-peak value (the difference between the maxi-
mum value and the minimum value) of the data that has been sampled and
holds the value until the next TIMING input signal is OFF.
TIMING input
0 (V)
OFF
In this period,the displayed
process value is “
”.
Input waveform
ON
p
b
(p-b)
p’
b’
(p’-b’)
Peak-to-peak
hold value
To cancel hold status, the RESET input must be ON.
Set operating parameter 3 according to the following instructions outlined in
the table and the flow diagram:
! $
Section 6-2