Omron K3TS, Operation Manual

Page: 56 / 97

With the Thumbwheel Switches Models, set values can be changed at any
time with the thumbwheel switches. The set values are registered 1.5 sec-
onds after the values have been set with the thumbwheel switches and the
Intelligent Signal Processor operates according to the new set values.
Retaining, Resetting Maximum/Minimum Values
The following is for when the K3TS is set to on operating parameter 3.
Operate as shown below:
The maximum displayed (process) value and the minimum displayed (pro-
cess) value recorded since power was applied or the RESET input turned ON
are retained. Press DATA/TEACH once to display the maximum value on the
PV display; press again to display the minimum value; and press again to
display the process value. When the RESET input is turned ON, both the
maximum and minimum values are cleared. While the RESET input is ON,
“
” is displayed.
Measured data
Input
RESET input
Displayed value
Maximum value
Minimum value
Maximum value
is indicated.
Thumbwheel Switches
Models
#
Section 6-3