Omron K3TS, Operation Manual

Page: 18 / 97

No. Function Name
12 TIMING input The TIMING input must be supplied from an open collector.
A photoelectric sensor or a proximity sensor can be used as a timing sensor.
+ 12 V
TIMING IN
GND
Timing sensor
13 HOLD With normal setting on operating parameter 3: When the HOLD signal to this terminal
is turned ON, measurement is stopped and the value input immediately before the
HOLD signal is retained. The relevant displayed value, comparative outputs, and BCD
data are also retained. While the HOLD signal is ON, the hold operation continues.
The effect of the HOLD operating parameter is canceled when the HOLD signal is
turned OFF.
When operating parameter 3 is in the state of Sampling hold, Maximum hold,
Minimum hold, and Peak-to-peak hold, the HOLD signal is disregarded.
14 ZERO When the ZERO input to this terminal is turned ON, the input value is calibrated to
zero. Turn OFF the current zero input signal to receive the next zero input signal on
this terminal.
15
to
17 Bank selection Select the bank for set values.
Bank no. Bank 1 Bank 2 Bank 4
0 OFF OFF OFF
1 ON OFF OFF
2 OFF ON OFF
3 ON ON OFF
4 OFF OFF ON
5 ON OFF ON
6 OFF ON ON
7 ON ON ON
The bank input is not available for the Thumbwheel Switches Models.
Section 3-1