/
Changing Set Values
Set values can be changed even in RUN mode. The values, however, cannot
be changed when the protect input is ON.
In order to change the set values on the Set Value LED Display Models, fol-
low the instructions outlined on the flow diagram, which shows how to
change set value H from 50.0 to 55.0:
Press the Display Key to display the H set values.
No key has been pressed for the
past 5 seconds.
When the Up or Shift Key is
pressed the digit blinks again.
Use the Shift Key to move the position of the blinking digit. Zero suppress is ef-
fective. The new set value is registered 2 seconds later.
Press the Up Key or Shift Key to set the new set value. Zero suppress is no
longer effective and the selected digit blinks.
Use the Up Key and Shift Key to change the set value.
Use the Shift Key to move the position of the blinking digit to the H set value to
change the value.
Press the Display Key to display the LL and HH set values.
Set Value LED Display
Models
#
Section 6-3
Summary of Contents for K3TS
