Omron K3TS, Operation Manual

Page: 26 / 97

When setting mode is selected, measurement is stopped. Some parameters
may not be displayed (i.e., cannot be selected or set), depending on the op-
erating parameter selected and whether the Model is a Display Model or Out-
put Model. For details, refer to the list of valid parameters by operating pa-
rameter see
6-1-3 List of Parameters for Each Model .
During operation, if you are unsure of the present status (such as the level or
parameter with which the setting has been made), press the Level Key for
one second to go one level lower. Be sure to write the set value again on that
level. The following list and accompanying diagrams describe how to set lev-
els in step-by-step fashion.
No. of pro-
cess values
to average
Setting level 3
Operating
parameter
1
Setting level 2
Input
range Baud
rate
Bank 0
set value Bank 1
set value Bank 2
set value
Protect
Press
1 s
Press
2 s
Low
Frequency
of use
High
Setting level 1
RUN mode
Press
1 s
Press
1 s
Press
1 s
Press
1 s
Press
1 s
Operating
parameter
2 Operating
parameter
3
Display
refresh
period
Setting Level Diagram
Commu-
nications
unit no.
Setting Procedure
1. Press the Level Key or Level and Up Keys to go to the
desired level.
2. Use the Shift Key to find the desired parameter.
3. Press the Display Key to access the parameter.
4. Use the Up or Shift Keys to input the desired value.
5. Leave the level you are in with the Display Key.
6. Return to the beginning with the Level Key or the Level
and Up Keys.
%# $ !
Section 6-1