24
General mounting considerations
Section 9-3
9-3-5
Installation of multiple systems
When two or more F3S-TGR-CL systems with the same scan code are
mounted in close proximity and in alignment with each other, precautions
should be taken to avoid one system interfering with another. This can be cor-
rected by mounting the transmitters and receivers back-to-back or stacked.
The scan code feature of the F3S-TGR-CL system allows for placement of
systems in close proximity and in line with each other. The distinctive coding
of the beams provide for unique operation of a system while in view of another
system with a different scan code. Two unique codes are available on the
F3S-TGR-CL.
9-3-6
Detection Zone (indication on the Front Label)
The system detection zone is delineated by the inside edge of the transmitter
and receiver endcaps and indicated by marks on the transmitter and receiver
unit (Except on Active - Passiv sytems the label is only on the Receiver
(Active) unit.). The area outside these marks is not protected. Position the
system so that it is only possible to access the danger point through the
detection zone.
9-3-7
Requirements for Perimeter Guarding
In perimeter guarding applications the F3S-TGR-CL system detection zone is
placed around the outside perimeter of a guarded machine. This placement
leaves space for personnel to stand between the detection zone and the haz-
ardous machine.
T
ran
s
mitter
Receiver
T
ran
s
mitter
Receiver
Machine 1
Machine 2
PREFERRED INSTALLATION
Code A
Code A
Machine 1
T
ran
s
mitter
T
ran
s
mitter
Receiver
Machine 2
Receiver
NOT RECOMMENDED INSTALLATION
Code A
Code A
Machine 1
T
ran
s
mitter
T
ran
s
mitter
Receiver
Machine 2
Receiver
Code A
Code B
r
e
w
o
P
s
ut
at
S
dr
a
u
G
k
a
er
B
kc
olr
et
nI
EDM
Operating Mode
Muting T
Muting X
Muting L
Enable
Manual reset
Disable
Automatic reset
4=OFF
4=ON
4=OFF
6=OFF
8=OFF
5=OFF
5=OFF
5=ON
6=ON
8=ON
4=OFF
4=ON
4=OFF
6=OFF
8=OFF
5=OFF
5=OFF
5=ON
6=ON
8=ON
SWA SWB
SWB
SW
A
SW
B
ON
OFF
ON
OFF
For further information please refer
to Installation and Operation manual
r
e
w
o
P
1
s
ut
at
S
r
a
F\r
a
e
N
2
s
ut
at
S
Code Settings
Code Selection
Coding
Code A
3=ON
4=OFF
3=OFF
4=ON
No Coding
Code B
SWA
For further information please refer
to Installation and Operation manual
Short Range
Long Range
1=ON
1=OFF
2=OFF
2=ON
1=ON
1=OFF
2=OFF
2=ON
4=OFF
4=ON
3=ON
3=OFF
SWB
SW
A
SW
B
Start of Detection zone
Start of Detection zone
Operating Mode
ON
OFF
ON
OFF
Label RX
Label TX
F06E-EN-03A+F3S-TGR-CL_K+OperManual.book Seite 24 Dienstag, 4. Oktober 2011 1:32 13