Omron EJ1 - 07-2008, Operation Manual

Page: 105 / 198

86
Operations from the Edit Device Parameters Window Section 5-2
2. Double-click the icon for the DeviceNet Communications Unit in the Net-
work Configuration Window, or right-click and select
Parameter and Edit
to display the Edit Device Parameters Window for the DeviceNet Commu-
nications Unit.
Note 1. Click the Upload Button to read the Unit configuration registered in the De-
viceNet Communications Unit.
2. Click the Upload Real Configuration Button to read the configuration of the
Temperature Controllers currently connected to the DeviceNet Communi-
cations Unit at that time.
3. Click the Reset Button to reset the DeviceNet Communications Unit. The
status of the Unit will be the same as if the power had been turned OFF
and ON again. Temperature Controllers, however, will not be reset during
operation.
4. Click the Default Setting Button to initialize all the DeviceNet Communica-
tions Unit settings, and return them to the factory setting status. The Con-
figurator screen will not return to factory setting status, however, so click
the Upload Button to read the settings again. The message monitor timer
must be changed to use this function. For details, refer to page 107.
!Caution Always turn OFF the OUT Enable Bit when using the Configurator to down-
load the parameters set in the Temperature Controller. If the OUT Enable Bit
are not OFF when downloading, the set values allocated with I/O and the set
values downloaded with the Configurator will compete, causing the set values
allocated using I/O to be enabled. For details on OUT Enable Bit, refer to
OUT
Enable Bit on page 65.
5-2-3 Setting DeviceNet Communications Unit Comment
A name can be assigned to the DeviceNet Communications Unit and
recorded in the Unit. The name can be entered using up to 32 standard char-
acters. The comment for the registered DeviceNet Communications Unit is