Omron CQM1H - 08-2005, Operation Manual

Page: 162 / 299

142
Cutting Fiber
•
Insert a 2.2-mm-dia. fiber into an E39-F4 Fiber Cutter and determine the length
of the fiber to be cut.
•
Press down the Fiber Cutter in a single stroke to cut the fiber.
•
When the fiber is cut, insertion marks are inscribed on the fiber. The portion
from the tip up to the insertion marks should be inserted into the E3X-MA11.
12.6
Insertion mark
2.2 dia.
•
To correctly inscribe the insertion mark, place the length of the fiber into the
Fiber Cutter in direction 1 as illustrated below, and press down firmly in direc-
tion 2.
1
2
•
The cutting holes cannot be used twice. If the same hole is used twice, the cut-
ting face of the fiber will be rough and the sensing distance will be reduced.
Always use an unused hole.
Use either one of the two rightmost holes to cut a thin fiber as follows:
1, 2, 3... 1. An attachment is temporarily fitted to each thin fiber before shipment.
Temporarily fitted
2. Secure the attachment after adjusting the position of it in the direction indi-
cated by the arrow.
3. Insert the fiber into the E39-F4 and cut.
Three holes for
standard fiber
(2.2 mm dia.)
Cutter E39-F4
Two holes for
thin fiber
Note Insert the fiber in the direction indicated by the arrow.
Connection of a Variety of Sensors
Section 3-4