Omron CQM1H - 08-2005, Operation Manual

Page: 161 / 299

141
3-3 Connection of CQM1-TU001 Remote Console
•
Remove the cover of the Unit and insert the console plug into the console con-
nector of the Unit so that the polarity of the console plug and the console con-
nector will match.
•
The console connector does not incorporate a lock mechanism. To disconnect
the console plug, hold the console plug and pull it straight out.
•
It is not possible to mount the cover to the Unit if the console plug is connected
to the console connector.
•
The console plug can be disconnected from the console connector even if the
Unit is turned on. Do not, however, disconnect the console plug while the sen-
sitivity of the Unit is being adjusted.
3-4 Connection of a Variety of Sensors
3-4-1 E3X-MA11 Optical Fiber Photoelectric Module
Connecting Fibers Set the fiber lock lever of the E3X-MA11 to FREE before inserting an optical fiber
cable to a fiber insertion mouth of the E3X-MA11 as shown in the following il-
lustration.
After inserting two optical fiber cables from the Fiber Units to the fiber insertion
mouths of the E3X-MA11, set the fiber lock lever to LOCK to secure the optical
fiber cables.
Insertion mark
Insert the optical fiber cables into the E3X-MA11 before mounting the E3X-MA11
to the Sensor Unit.
Note If the tips of the two optical fiber cables are not inserted into the E3X-MA11 to the
insertion marks, the sensing distance may be reduced.
Disconnecting Fibers To disconnect the optical fiber cables from the E3X-MA11, hold and pull out the
optical fiber cables carefully. Before disconnecting the optical fiber cables from
the E3X-MA11, be sure to set the fiber lock lever to FREE.
Note If the optical fiber cables are disconnected without setting the fiber lock lever to
FREE, the optical fiber cables may break and the E3X-MA11 may malfunction
due to fragments of broken optical fiber cables.
Connection of a Variety of Sensors
Section 3-4