3-15
Section
Printing Device Parameters
92
1, 2, 3...
1. Select “Tool” from the online menu bar.
2. Select “Device Parameters Setup” from the Tool menu.
The Set Parameters window will be displayed.
The “Service Code” values show the service names used by the Configura-
tor when reading and writing the device parameters. These values cannot
be changed.
3. Set the desired Slave’s node address in the “Setup Target Node Address”
area.
4. Input the “Class,” “Instance,” and “Attribute” settings and select the proper
“Data Unit” and “Data Size” settings.
5. When reading the parameter settings from the Slave, click on “Read from
Device.”
The parameters will be read from the Slave and displayed in the “Data” area.
The values will be displayed in the specified “Data Unit” and “Data Size.”
6. When writing parameter settings from the Slave, input the data in the “Data”
area with the specified “Data Unit” and “Data Size.” Click on “Write to
Device” to write the parameter settings to the Slave.
7. Repeat steps 4 through 6 as required.
8. When the Slave parameters have been set, click on “Close” to exit the Set
Parameters window.
3-15 Printing Device Parameters
The “Print” command can be used to print the device parameters of the network
configuration being displayed.
1, 2, 3...
1. To print a partial list of device parameters, select the desired devices.
2. Select “File” from the menu bar.
3. Select “Print.” The Print window will be displayed.