2-3
Section
PCMCIA Card Installation
31
Setup Procedure for Non-OSR2 Windows 95 with CompoBus/D Version 1.12 or
Earlier
Use the following setup procedure if the Windows 95 system version is shown as
“4.00.950” or “4.00.950a” and CompoBus/D Configurator Version 1.12 or earlier
has been installed. In this case, a PCIC or compatible PCMCIA controller is used
as the PCMCIA Card driver for the CompoBus/D Configurator. This driver must
be replaced with a dedicated driver.
Before starting the setup procedure, remove any PCMCIA Cards (including
those for the CompoBus/D Configurator) that are currently being used. Since
the PCMCIA Card can’t be used temporarily during the setup, it may not be pos-
sible to continue the setup operation midway through the operation.
Upgrading the PCMCIA Card Driver
1, 2, 3...
1. Insert the PCMCIA Card installation disk provided into the floppy disk drive.
2. Install the PCMCIA Card when the Windows system is active.
3. Click on the “Start” button, select “Control Panel” from the “Settings” menu,
and double-click on the “Add New Hardware” icon in the Control Panel win-
dow.
4. The Add New Hardware Wizard window will be displayed. Then, click on
“Next.”
Before Starting the Setup
