3-6
Section
Creating and Editing Master Parameters
61
vi) Click on “Register” to register the node with the specified node
address. (If a node address registered to another node has been spe-
cified, the other node’s information will be overwritten.)
3. Remove Slaves as needed.
To remove a registered Slave, click on the Slave to select it and then click on
“Remove.”
Remote I/O Allocation
1, 2, 3...
1. Select “I/O Allocation” from the top of the window. The following window will
be displayed.
Output area settings
Input area settings
Setup Slave display area
Block-by-block
allocation settings
The width of the columns in the Setup Slave display area can be adjusted
just like the width of the columns in the device list display area.
The order in which the Slaves are listed can be changed, too. To change the
listing order, click on the headings in the Setup Slave display area. The fol-
lowing table shows the listing orders that can be selected.
Heading
Listing order
Single-click
Double-click
Node Address Product
Node addresses
(Ascending)
Node addresses
(Descending)
OUT Word
Output word addresses
(Ascending)
Output word addresses
(Descending)
Size (output)
Number of output bytes
(Ascending)
Number of output bytes
(Descending)
IN Word
Input word addresses
(Ascending)
Input word addresses
(Descending)
Size (input)
Number of input bytes
(Ascending)
Number of input bytes
(Descending)
Exp (See note.)
Explicit Slave connections
only (Bottom)
Explicit Slave
connections only (Top)