2-3
Section
PCMCIA Card Installation
36
If the CompoBus/D Configurator is to be upgraded successively, follow the
procedure described in 2-4 CompoBus/D Configurator Installation. The
upgrading procedure is essentially the same as the installation procedure.
Setup Procedure for OSR2 Windows 95 with CompoBus/D Configurator Version 1.12
or Earlier
Use the following setup procedure if the Windows 95 system version is shown as
“4.00.950B” or “4.00.950C” and CompoBus/D Configurator Version 1.12 or ear-
lier has been installed. In this case, a PCIC or compatible PCMCIA controller is
used as the PCMCIA Card driver for the CompoBus/D Configurator. This driver
must be replaced with a dedicated driver.
Before starting the setup procedure, remove any PCMCIA Cards (including
those for the CompoBus/D Configurator) that are currently being used. Since
the PCMCIA Card can’t be used temporarily during the setup, it may not be pos-
sible to continue the setup operation midway through the operation.
Upgrading the PCMCIA Card Driver
1, 2, 3...
1. Insert the PCMCIA Card installation disk provided into the floppy disk drive.
2. Install the PCMCIA Card when the Windows system is active.
3. Click on the “Start” button, select “Control Panel” from the “Settings” menu,
double-click on the “System” icon in the Control Panel window, and select
the “Device Manager” tab from the top of the System Properties window
(refer to page 19). Click on “+” to the left of “PCMCIA socket” to display the
drivers.
Before Starting the Setup
