Appendix B
Error Messages
101
Error message
Error processing
Temporary file can not be created.
A working file couldn’t be created, so the process couldn’t be
continued.
Error occurred during writing Network
Configuration.
An error occurred while writing data.
Error occurred during reading Network
Configuration.
An error occurred while reading data.
Parameters not selected.
Target parameters haven’t been selected. Select target parameters.
Only one file can be read.
More than one file can’t be read.
Wrong Parameter.
A parameter is incorrect. Check the parameters.
Can not execute due to insufficient memory.
The command can’t be executed because of insufficient memory.
Valid card has not defined.
Valid DeviceNet interface card settings haven’t been made. Make the
necessary card settings.
Valid Slave Device has not been set. Remote
I/O Communication will stop.
There isn’t valid I/O allocation information in the Master parameters
that are being written to the device. If the processing is continued,
remote I/O communications will stop.
No valid data.
There is no valid data. Check the parameters.
Can not set due to invalid device.
The processing can’t be performed because the target device is not a
valid device. Specify a valid device.
Not valid parameter setup.
The specified parameters contain incorrect data. Input correct data.
Valid Master Device not exist.
A command that requires a target Master device has been selected,
but there is no target Master device.
Resource can not be used.
The other node is busy.
Starting Remote I/O Communication failed.
Remote I/O communications could not be started in the specified
Master.
Stopping Remote I/O communication failed.
Remote I/O communications could not be stopped in the specified
Master.
Starting Log Viewer failed. Refer to xxxxxxxx.
The external program for log file reference couldn’t be started. See the
reference indicated (xxxxxxxxxx).