2-3
Section
PCMCIA Card Installation
28
Setup Procedure for OSR2 Windows 95
Use the following setup procedure if the Windows 95 system version is shown as
4.00.950B or 4.00.950C.
Before starting the setup procedure, remove any PCMCIA Cards (including
those for the CompoBus/D Configurator) that are currently being used. Since
the PCMCIA Card can’t be used temporarily during the setup, it may not be pos-
sible to continue the setup operation midway through the operation.
PCMCIA Card Setup
1, 2, 3...
1. Insert the PCMCIA Card installation disk provided into the floppy disk drive.
2. Install the PCMCIA Card when the Windows system is active. The PCMCIA
Card will be recognized as new hardware and the Update Device Driver
Wizard window will be displayed. Click on “Next.”
Note Make sure that the PCMCIA Card installation disk is still in the floppy
disk drive before starting this step.
3. Windows 95 will recognize the driver stored on the floppy disk. Click on “Fin-
ish.”
4. The following message box will appear asking the user to insert the
PCMCIA Card installation disk. Since the floppy disk has already been
inserted in step 1, just click on “OK.” The driver will be installed.
Before Starting the Setup
