3-8
Section
Editing MULTIPLE I/O TERMINAL Unit Parameters and Monitoring Status
77
The Unit configuration cannot be changed in online mode.
To change the settings of the I/O Units connected to the DRT1-COM Commu-
nications Unit, click on “Set” to the right of the desired I/O Unit.
The following setting window for the I/O Unit will be displayed. The contents of
the window differs according to the type of I/O Units.
Example: GT1-AD08MX Analog Input Unit
To change the parameter values, either select the desired parameter and then
click on “Set Parameters,” or double-click that parameter.
The setting window for the selected parameter will be displayed.
The setting procedure is the same as that for setting Slave devices. Refer to 3-14
Connecting Another Company’s Slaves.
To return all parameters to their default values, click on “Default Setup.”
When the setting procedure is completed, click on “OK.” The settings will be
saved and the current window will return to the Edit Device Parameters window
for the DRT1-COM.
The specified MULTIPLE I/O TERMINAL Unit parameters and I/O Unit parame-
ters can be saved as a file, and the saved parameters can also be read from the
file.
This file contains the DRT1-COM Communications Unit parameters and the
parameters for the I/O Units connected to the DRT1-COM.
To save or read the parameters, click on “Write to File” or “Read from File” in the
Edit Device Parameters window for the DRT1-COM Communications Unit. The
window for specifying the folder and the file to be saved or read will appear.
The specified MULTIPLE I/O TERMINAL Unit parameters and I/O Unit parame-
ters can be written to or read from the DRT1-COM Communications Unit.
All the DRT1-COM Communications Unit parameters and all the parameters for
the I/O Units connected to the the DRT1-COM Communications Unit will be writ-
ten or read at one time.
To write or read the parameters, click on “Write to File” or “Read from File” in the
Edit Device Parameters window for the DRT1-COM Communications Unit.
Before the parameters are written to a device, a confirmation window will be dis-
played.
Note When these parameters are written to a device, an error will occur if the unit con-
figuration specified with the CompoBus/D Configurator differs from that of the
DRT1-COM. Before writing the parameters to the device, make sure that these
Unit configurations match.
Setting Unit Parameters
Saving and Reading
MULTIPLE I/O TERMINAL
Unit Parameters
Writing and Reading
MULTIPLE I/O TERMINAL
Unit Parameters to and
from Devices
