3-2
Section
Main Window (Device List Window)
50
This area displays information for the selected device. When two or more
devices have been selected, information for the device selected last is dis-
played.
This area displays general status information, such as the condition of pro-
cesses being executed by the Configurator or a description of the selected menu
command.
This area displays the condition of the Configurator as follows:
•
Node address:
When online, the node address of the Configurator’s node is shown.
When offline, no information is displayed.
•
Communication rate:
When online, the baud rate set for the Configurator is shown.
When offline, no information is displayed.
•
Network connection status:
Indicates whether the Configurator is online, offline, or in bus-off status. The
online status is indicated in blue and bus-off is indicated in red.
•
Caps Lock status
•
Num Lock status
•
Scroll Lock status
Note When a bus-off error occurs, go offline momentarily and then go online again.
Device Icons in the Device List
A different icon is displayed for each type of device, as shown below:
: OMRON DeviceNet Configurator
: Generic Device
: Control Station
: AC Drives
: Motor Overload
: Limit Switch
: Inductive Proximity Switch
: Photoelectric Sensor
: Generic Purpose Discrete I/O
: Encoder
: Resolver
: Generic Purpose Analog I/O
: Communications Adaptor (OMRON Master)
: Bar code Scanner
: Position Controller
: Weight Scale
: Message Display
: DC Drives
: Servo Drives
: Contactor
: Motor Starter
: Soft Start
: OMRON Master
(when the Master parameters are invalid)
: Unknown Device
: Non-existent Device
Note
1. When the listing order is based on the remote I/O communication configura-
tion, Slaves with node addresses outside of the display range will be listed
as non-existent (
×
) even if they are registered in the Master’s scan list. Set
the display range with the “View”
→
“Set Display Range” menu command.
Device Information
Status Bar
CompoBus/D
Configurator Status