Omron 3G3AX-MX2-PRT-E, User Manual

Page: 84 / 116

70
Maintenance and Inspection
Section 5-3
Then align the larger hole on the
Inverter connector (no.3) with the
threaded hole (no.6) in the Inverter.
Push the Inverter connector into
place.
Step 8 Move the Option Board Cable (no.2) to the left with your finger, so the Option
Board Cable is not pinched between the Option Board and the Inverter Front
Cover.
Note Prevent a pinched Option Board Cable, as shown in position A.
Note Do not pull on the Option Board Cable.
Note Do not let the Option Board hang on the Option Board Cable.
Insert the Option Board approximately 1 cm above the down-position into the
Front cover of the Inverter. See figure 1above.
Slide the Option Board down. See figure 2 above.
The snap-fits of the Option Board
(no.5) will be locked by the snap-fits
in the Front cover (no.4).
2
4
1
4
m c 1 ±
3
Connector
Option Board bottom side
5
I111E-EN-02+3G3AX-MX2-RX-PRT+OperManual.book Seite 70 Donnerstag, 8. September 2011 11:53 11