Omron 3G3AX-MX2-PRT-E, User Manual

Page: 28 / 116

14
How to mount the Option Board on the Inverter
Section 2-3
2-3-2 How to install the Option Board on the RX Inverter
2-3-2-1 Preparation
When the Option Board is mounted on the RX Inverter, the Digital Operator
Display can not be directly connected back on the RX Inverter.
There are two solutions:
Commissioning with
Digital Operator Display This option is recommended, however it does require a straight Ethernet
cable.
Step 1 Mount the Option Board according paragraph 2-3-2-2 Mounting sequence of
the Option Board on the RX Inverter on page 14 .
Step 2 Connect the Digital Operator Display using the 3G3AX CAJOP300-EE cable
or straight Ethernet cable.
Step 3 Set the desired parameters of the RX Inverter with the Digital Operator Dis-
play.
Commissioning via Profibus
Step 1 Configure the essential Profibus communication parameters before mounting
the Option Board. See also paragraph
3-2 Configuring the Network on page
26 :
• Step 1 on page 23: Set the Device Profile using parameter P182.
• Step 3 on page 23: Set the Inverter parameter P180 PROFIBUS
Node Address.
Step 2 Mount the Option Board according paragraph 2-3-2-2 Mounting sequence of
the Option Board on the RX Inverter on page 14 . Set the desired parameters
of the Inverter (Also referenced in this paragraph).
Step 3 Configure the Inverter without Digital Operator:
•Use the OMRON CX-Drive tool, or
•Use PROFIdrive DP-V1 Parameter Channel to access the parameters
directly (refer to APPENDIX E PROFIdrive DP-V1 Parameter Chan-
nel ).
2-3-2-2 Mounting sequence of the Option Board on the RX Inverter
Step 1 Remove from the RX Inverter:
1. Digital Operator Display
2. Terminal cover
3. Front Cover
4. Operator connector.
I111E-EN-02+3G3AX-MX2-RX-PRT+OperManual.book Seite 14 Donnerstag, 8. September 2011 11:53 11