18
How to mount the Option Board on the Inverter
Section 2-3
Step 8
Unscrew the mounting screws of the
Terminal cover nearly completely
from the plastic rings (no.1).
Remount the Terminal cover under
the Option Board onto the Inverter
(no.2).
Tighten the two screws (no.1).
Step 9
Connect the Digital Operator Display
via a 3G3AX CAJOP300-EE cable or
via a straight EtherNet cable with the
RJ45 connector in the Inverter.
Step 10
Define needed and desired parameters of the Inverter and set them according
SECTION 3 Configuring Drive Parameters and Option Board on page 23
and
also according
SECTION 4 Operations and Monitoring on page 29
.
I111E-EN-02+3G3AX-MX2-RX-PRT+OperManual.book Seite 18 Donnerstag, 8. September 2011 11:53 11
Summary of Contents for 3G3AX-MX2-PRT-E
