16
How to mount the Option Board on the Inverter
Section 2-3
Step 5
Move the Option Board Cable (no.2)
to the left with your finger, so the
Option Board Cable is not pinched
between the Option Board and the
Inverter Front Cover.
Note
Prevent a pinched Option Board
Cable, as shown in position A.
Note
Do not pull on the Option Board
Cable.
Note
Do not let the Option Board hang on
the Option Board Cable.
Insert the Option Board approximately 1 cm above the down-position into the
Front cover of the Inverter. See figure 1above.
Slide the Option Board down. See figure 2 above.
The snap-fits of the Option Board
(no.5) will be locked by the snap-fits
in the Front cover (no.4).
A
1
2
3
2
4
1
4
m
c
1
±
3
Connector
Option Board bottom side
5
I111E-EN-02+3G3AX-MX2-RX-PRT+OperManual.book Seite 16 Donnerstag, 8. September 2011 11:53 11
Summary of Contents for 3G3AX-MX2-PRT-E
