Oki Pro1040, Maintenance Manual

Page: 113 / 118

- 113 -
Specifications
„
Full-sheet label paper (with black marks)
W2
D C
L
4
L
6
B
L
BW
BW
BW
B
L
B
L
B
L
L
1
L
1
W1
W6 W5
L
4
L
4
L
4
L
5
L
5
L
5
L
6
L
6
L
6
A
L
2
A
L
2
A
L
2
A
L
5'
B
B
B
Paper
feed
direction
Printing range
Liner
Black mark
Winding direction
Outside winding: Printable surface faces out.
Inside winding: Printable surface faces in
Paper weight 0.07 to 0.25 mm (0.003 to 0.0098 inches)
Core Inner diameter: 76.2 mm (3 inches)
Outer diameter 203.2 mm (8 inches) or less
Other W1 : Liner width 29.4 to 130 mm (1.1575 to 5.12 inches)
W2 : Label width 25.4 to 126 mm (1 to 4.9606 inches)
W5 : Left liner area (dry edge) 2 to 25.4 mm (0.0787 to 1 inch)
W6 : Right liner area (dry edge) 2 to 25.4 mm (0.0787 to 1 inch)
L1 : Black mark interval
15.9 to 1324.0 mm (0.626 to 52.126 inches)
* The black marks contain carbon.
L2 : Paper length
12.7 to 1320.8 mm (0.5 to 52 inches)
L4 : Cut size when in cut mode
101.6 mm (4 inches) or more
However, if the length of one label is less than 101.6 mm
(4 inches), then the shortest length is 101.6 mm
(4 inches) as multiple sheets are cut
L5 : Upper edge cutting margin
1.7 mm (0.067 inches)
L5' : Position of leading edge of
paper
1.2 to 4.0 mm (0.0472 to 0.1575 inches) Length of
leading margin when paper is loaded
L6 : Lower edge cutting margin
1.5 mm (0.059 inches)
BW : Black mark width
More than 5 mm (0.197 inches) from edge of paper (*1);
maximum is width of paper W1 from edge of paper
BL : Black mark length
3 mm (0.12 inches)
A : Top margin
2.12 mm (0.0835 inches) or more
B : Bottom margin
3.2 mm (0.126 inches) * In practice, it is the length of the gap
C : Left margin
2.12 mm (0.0835 inches) or more
D : Right margin
2.12 mm (0.0835 inches) or more
(*1) If an accurate position to start printing on the leading edge is needed, use a black mark in the center of the paper's width.