4-17
4.14 Error Codes
If an error occurs during a communication, a check messages will be printed. The following provides
an explanation of check messages.
•
A possible solution to the problem
•
The sending location (if the remote fax stores a Location ID of its own)
•
The result --- which is a special error code
•
The sample document.
You will also see a code listed in the Result column of the report. Result codes indicate the specific
problem encountered:
•
“D” codes occur while dialling
•
“R” codes occur during reception
•
“T” codes occur during transmission
Here is a list of error codes the fax machine may print.
Dialling errors
Error code
Message *
Explanation
D.0.1
B
Congestion tone was detected. Try the call again.
D.0.2
C
The remote fax machine is busy. Call again.
D.0.3
H
The STOP button was pressed while the unit was dialing. Try the
call again.
D.0.6
F
Autodialler number was not stored in the unit. Store the telephone
number in the unit’s autodialler number.
D.0.7
A
The dialling time out occurred because the remote unit did not
answer. Try the call again.
D.0.8
B
Dial tone was not detected. Try the call again.
*: See “Communication Error messages” on next page.
Reception errors
Error code
Message *
Explanation
R.1.1
A
T1 time-out. The calling unit was not a fax machine or the
transmitting unit is having difficulties.
R.1.2
A
Compatibility error. The calling unit is attempting to poll a document
that does not exist, has secure transmission enabled or is
attempting to transmit to a non existent secure mailbox.
R.1.4
H
The STOP button was pressed during reception.
R.1.5
A
The fax machine didn’t detect the silence period for ending channel
when receiving RCR.
R.2.1
A
A Compatibility error (closed network, junk fax detection) occurred.
R.2.3
A
No response to FTT. Poor phone line conditions made fax
communication impossible. Enable the one second pause after
CED on Memory Switch C:0. Also try increasing the echo wait time
on Memory Switch C:1 if echo is on the line.
R.3.1
A
No response to CFR. DCN was received from the transmitter. Poor
line conditions made communication impossible. Adjust the echo
wait time on Memory Switch C:1. Try increasing the output levels
via Machine Parameter A:1.
R.3.3
A
Too many errors were detected during data reception. The carrier
was interrupted. Increase the data error rate on Memory Switch
C:0.
R.3.4
A
DCN was received after FTT. Communication was not possible at
2400 bps. Poor phone line conditions prevented fax communication.
Enable the Eye Quality Check on Memory Switch D:1 and D:2.
R.3.5
A
Poor line conditions prevented reception.
*: See “Communication Error messages” on next page.
Summary of Contents for OKIOFFICE 120
