Oki OKIOFFICE 120, Maintenance Manual

Page: 58 / 197

3-17
Memory Switch A:5 - Dialer
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 1 Factory use only
5 1 Factory use only
4 0 Factory use only
3 0 Factory use only
2 0 Dual ring detection
0: No
1: Yes
When enabled, the unit is able to auto answer an
incoming ring with an off time of 120 - 60 ms.
1 0 Long ring detection
0: No
1: Yes
Allows the unit to respond to an incoming ring if the
ring on-time is longer than two seconds.
0 1 Ring frequency detection
0: No
1: Yes
When disabled, the unit will not check the ring
frequency of incoming rings.
Memory Switch A:6
∼∼
A:9 --- Factory use only
Memory Switch B:0 - Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 1 Busy tone detection
0: No
1: Yes
Sets this switch to “0” if the ring tone of remote unit
is mistaken for a busy signal.
6 0 Fallback pattern (bps)
2400 4800 7200 9600 14400
Set at 0: 2 times 2 times 2 times 2 times 2 times
Set at 1: 4 times 1 times 1 times 1 times 1 times
5 0 Overseas mode
0: No
1: Yes
Re-enables echo suppression that is disabled by
the CED signal (2100 Hz). Also ignores the first DIS
signal and transmits the DCS signal in response to
the second DIS signal.
4 0 V.29 Echo Protect tone
0: No
1: Yes
International telephone lines equipped with echo
suppression will cut the beginning portion of the
transmitted information which may cause the
receiver not to receive the training and data. To
protect the received image from degrading, a 0.5
second Echo Protect tone is placed prior to the
training using G3 high speed modem training
(V.29).
3 1 Maximum transmit speed (kbps)
2.4 4.8 7.2 9.6 12 14.4 16.8 19.2 21.6 24 26.4 28.8 31.2 33.6
2 1 0 0 0 0 0 0 0 0 1 1 1 1 1 1
0 0 0 0 1 1 1 1 0 0 0 0 1 1
1 0 0 0 1 1 0 0 1 1 0 0 1 1 0 0
0 1 0 1 0 1 0 1 0 1 0 1 0 1
0 1
Note: It is maximum 33.6 kbps only when AL-100 optional module is attached to OKIOFFICE
120 model. Standard OKIOFFICE 120 model is maximum 14.4 kbps.