Octagon 6000 Series, User Manual

Page: 153 / 233

20-4
CAMBASIC 6000 Series user’s manual
AUTORUN Autoruns a CAMBASIC program
BCCF Returns the binary check code (BCC)
BCD Converts binary to 4-digit BCD
BIN Converts BCD to binary
BIN$ Returns the binary representation to string form
BIT Reads or writes specific bits at I/O addresses
CLEAR DISPLAY Clears display
CLEAR TIMER Clears software timer
CONFIG AIN Selects drivers for specified A/D
CONFIG AOT Selects drivers for specified D/A
CONFIG BAUD Configures COM port parameters
CONFIG COM$ Configures COM port
CONFIG COUNT Configures software counter
CONFIG DISPLAY Configures display
CONFIG KEYPAD$ Configures keypad
CONFIG PIO Configures 82C55 parallel port
CONFIG TIMER Configures software timer
COUNT Returns the count from software counter
CRC Returns the cyclic redundancy (CRC) of a
memory block
DEC Fast decrement of a numeric variable
DELAY Introduces delay to program flow
DEV Returns standard deviation of an array
DINP Inputs a 16-bit value to I/O address
DISPLAY Prints to a display
DOSINT Executes DOS software interrupt
DOUT Writes to a 16-bit value to I/O address
DPEEK Read a 16-bit value from memory
DPOKE Writes a 16-bit value to memory
ERROR Returns error code or simulates run time error
EXIT DO Exits DO loop unconditionally
EXIT FOR Exits FOR loop unconditionally
INC Fast increment of variable
HALT Halts processor for lowest power mode
INDENT Declares the network identification code
KEYPAD$ Reads the keypad
MAXVAL Returns maximum value of elements in an array
MEAN Returns mean value of the elements in an array
NET$ Returns a string from the RS-485 network
NLIST Lists without a line number
NLLIST Lists to the line printer without a line number
ON COUNT Specifies condition for branching by the state of
the software counters
ON ERR Specifies location for branching when errors
occur